Installing Exterior Vinyl Shutters on a Brick House

Installing exterior vinyl shutters is normally a simple, easy challenge when installing on wood or siding. However, if you’re putting in plastic shutters on a brick floor, some matters have got to be taken into consideration.

To begin with, some bricks are bolstered with steel. This makes it an particularly tricky assignment to drill by way of the brick. I attempted this as soon as and it took me all day simply to mount three pairs of shutters due to the fact I needed to always swap again and fourth between a masonry drill bit and a steel drill bit.

Another thing to recall is that the life of the condominium will frequently be longer than the life of the vinyl shutters. It is rather possible that the character who buys the house from you (every time that day is also) won’t like the shutters and can want to take them down. Then again they’ll want to install operable exterior shutters in their location. So we must be sure to make eliminating them sooner or later an convenient system.

Both of these issues may also be solved by way of drilling into the mortar between the bricks instead of into the bricks themselves. The main rationale for this is considering the fact that it is so much less complicated to patch the mortar than it is to fill and fit the colour and texture of the bricks.

The next factor to do not forget is whether you wish to have a everlasting set up or if you need the choice to take your window shutters down. The important motive why you possibly can wish to take down your vinyl shutters could be to paint the residence. Since Brick wall panels more commonly isn’t painted a permanent set up will suffice in most situations. Nevertheless, if phase or your whole mounting surface is painted you can also want to make them detachable for future upkeep. To mount the shutters permanently, you can order vinyl exterior shutters with shutter-loks (frequently referred to as shutter locks or shutter plugs). To make a detachable installation, which you could get painted steel screws to mount your window shutters and use some masonry anchors to hold them in position.

In the end, you will additionally have to take into consideration the construction of the house. If the window has a slope sill you are going to have got to depart a 1/four inch hole between the sill and the bottom of the shutter to permit rain, snow, and ice to empty from the window. You probably have a brick mould you will have got to order the correct measurement of exterior shutters to stretch from the top to the backside of the window opening.